|
|
MATERIAL SAFETY
DATA SHEET
|
|
SECTION I MANUFACTURER
IDENTIFICATION
|
PRODUCT NAME: Phosphate
Free Prep Wash
PRODUCT CODE: 193-1040BK
HMIS CODES: H F
R P 100G
TRANSTAR AUTOBODY TECHNOLOGIES
2040 HEISERMAN DR.
BRIGHTON, MI 48116
EMERGENCY PHONE: 800-424-9300
CHEMTREC
INFORMATION PHONE: 810-220-3000
NAME OF PREPARER: J
Papson
|
SECTION II -
HAZARDOUS INGREDIENTS/SARA III INFORMATION
|
| Reportable
Components |
|
Gas
Number |
Vapor
Pressure
HG @ TEMP |
Weight
Percent |
*** NO REPORTABLE QUANTITIES
OF HAZARDOUS INGREDIENTS ARE PRESENT ***
*** No toxic chemical(s)
subject to the reporting reguirements of section 313 of Title III
and of 40 CFR 372 are present. *** This product does not contain
chelical(s) known to the State of California to cause cancer or
birth defects or other reproductive harm. Employee exposures must
be kept below the above exposure limits (OSNA PEL, ACCIR TLV, OTI[ER)
while working with this product.
|
SECTION III -
PHYSICAL/CHEMICAL CHARACTERISTICS
|
BOILING RANGE:
n/a
SPECIFIC GRAVITY (H2O=1): 1.00
VAPOR DENSITY: N/A
EVAPORATION RATE: Slower than Butyl Acetate
MATERIAL V.O.C.: 0.00 lb/gl COATING V.O.C.: 1.21 lb/gl
SOLUBILITY IN WATER: Soluble
APPEARANCE AND ODOR: Cloudy, colorless liquid with orange
odor.
|
SECTION IV -
FIRE AND EXPLOSION HAZARD DATA
|
FLASH POINT:
>212 Deg F
METHOD USED: TCC
FLAMABLE LIMITS IN AIR BY VOLUME - LOWER: n/a
FLAMABLE LIMITS IN AIR BY VOLUME - UPPER: n/a
EXTINGUISHING MEDIA: Foam, Alcohol Foam, C02, Dry Chemical,
Water Fog, Other.
SPECIAL FIREFIGHTING
PROCEDURES
Full fire fighter eguipment including SCBA should be worn to avoid
skin contact and inhalation of concentrated vapors. Kinimi~e skin
exposure. IIighly toxic fumes may be generated by therial decomposition.
UNUSUAL FIRE AND EXPLOSION
HAZARDS
Closed containers may explode when exposed to extreme heat or burst
when contaminated with water (CO2 gas evolved). Hazards apply to
empty containers.
|
SECTION V - REACTIVITY
DATA
|
STABILITY:
Stable
CONDITIONS TO AVOID
Excessive heat, open flames, poor ventilation1 corrosive atmospheres.
Confined areas when working with the product. Strong Acids, Strong
Bases
INCOMPATIBILITY (MATERIALS TO AVOID)
INFORMATION NOT AVAILABLE.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS
Carbon monoxide, carbon dioxide, oxides of nitrogen.
HAZARDoUS POLYMERIZATION: WILL NOT OCCUR.
|
SECTION VI -
HEALTH HAZARD DATA
|
INHALATION HEALTH
RISKS AND SYMPTOMS OF EXPOSURE
No hazard in normal product use.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Minimal hazard to the eyes in normal product use. Minimal irritation
to the skin.
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Non-irritating to the skin.
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
No hazard in normal product use.
HEALTH HAZARDS (ACUTE AND CHRONIC)
ACUTE:
INHALATION - odor may he offensive.
EYE CONTACT - Mild irritation.
SKIN CONTACT - Mild irritation.
INGESTION - May cause mild gastrointestinal irritation, voliting,
nausea, & diarrhea.
CHRONIC:
No chronic health effects known.
CARCINOGENICITY:
NTP CARCINOGEN: No
IARC MONOGRAPHS: No
OSHA REGULATED: No
This product has not
heen tested for carcinogenic effects. Some material in this product
may he identified by NTP, IARC and/or OSEA as carcinogenic, indicated
above as "Yes". No further information available.
MEDICAL CONDITIONS
GENERALLY AGGRAVATED BY EXPOSURE
Asthma and other respiratory disorders (bronchitis, emphysema, hyperactivity),
skin allergies, eczema.
EMERGENCY AND FIRST AID PROCEDURES
SEEK MEDICAL ATTENTION FOR ALL OVER-EXPOSURES AND PERSISTANT SYMPTOMS.
INHALATION - Move person to fresh air. If breathing difficulty
persists seek medical attention.
EYE CONTACT - Flush with large quantities of water for 15
minutes.
SKIN CONTACT - Wash thoroughly with soap and water.
INGESTION - Induce vomiting. Seek mediate medical attention.
|
SECTION VII -
PRECAUTIONS FOR SAFE HANDLING AND USE
|
STEPS TO BE TAKEN
IN CASE MATERIAL IS RELEASED OR SPILLED
Absorb spilled product in an inert material such as sand, earth
or other suitable material. Transfer to an appropriate container
for disposal.
WASTE DISPOSAL METHOD
This product when disposed represents a non-hazardous waste, as
identified in 4OCF~6l. It is the responsibility of each waste generator
to identify the proper classification of their waste streams.
PRECAUTIONS To BE TAKEN IN HANDLING AND STORING
Use in cool, well-ventilated areas. Keep containers closed when
not in use. Keep away frou incompatibles. Keep away from excessive
beat and open flames. Follow all HSDS/label precautions even after
container is emptied because they may retain product residues. Store
in a cool area away fron heat and flames. Do not reuse container
when empty.
OTHER PRECAUTIONS
Smoking in area where this material is used should he strictly prohibited.
Use with adequate ventilation. If normal ventilation is not adequate
use exhaust fan. Always use protective clothing and equipment. Remove
all contaminated clothing and wash throroughly when finished workinq.
Keep food and drink away from material and from area where material
is being used.
|
SECTION VIII
- CONTROL MEASURES
|
RESPIRATORY PROTECTION
When working with this material, utilize engineering controls such
as ventilation and fans to reduce emission levels below the tine
weighted linits (ACGIH TLV & OSHA PEL) found in Section II.
Use a MSHA/NIOSH approved cartridge respirator or suitable respiratory
protection to keep airborne mists and vapor concentrations below
the PEL & TLV limits. When using in poorly ventilated and confined
spaces, use a fresh-air supplying respirator or a self-contained
breathing apparatus.
VENTILATION
General mechanical ventilation or local exhaust should he utilized
to keep Ventilation equipnent Rust he explosion proof.
PROTECTIVE GLOVES
Impermeable chemical gloves for skin protection.
EYE PROTECTION
Use safety glasses or splash goggles.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Rubber apron, work shoes, appropriate chemical resistant gloves.
WORK/HYGIENIC PRACTICES
Eye washes and safety showers in the workplace are recomended. Avoid
contact with skin and eyes. Avoid breathing vapors. Wash hands thoroughly
after using and before eating, drinking or smoking. Employee education
and training in the safe use and handling of this product is required
under the OSHA Hazard Communication Standard 29CFR1200.
To the best of our knowledge,
the information contained herein is accurate, obtained fron sources
believed by Transtar Autobody Technologies to he accurate. As with
all chemicals, KEEP AWAY FROM CHILDREN AND ANIMALS. FOR PROFESSIONAL
USE ONLY. The hazard information contained herein is offered solely
for the consideration of the user, subject to his own investigation
and verification of compliance with applicable regulations, including
the safe use of the product under every foreseeable condition.
|